Globalscale ESPRESSObin v5

ESPRESSObin v5

The ESPRESSObin v5 is a small single board computer similar to a raspberry pi. It has 3 ethernet ports, a USB 3.0 port, as well as an internal mPCIe slot.

Files

MassMesh MeshNode Firmware (Latest)

OpenWrt Stable 18.06.2 Image

OpenWrt Snapshot Image

Yggdrasil 0.5.3 Package

Build The Image

Use profile meshnode and device espressobin and see Building the Firmware for instructions on using the ImageBuilder.

Modify U-Boot Variables

Before the ESPRESSObin will boot our Open WRT image from an SD card, we will need to modify just a few U-Boot variables. More information about this can be found in this commit message and these docs.

In order to connect to your modify ESPRESSObin's U-Boot variables, you'll need to establish a serial connection.

Once you've established a serial connection, change the bootcmd variable using the following command:

setenv bootcmd 'mmc dev 0; ext4load mmc 0:1 $kernel_addr $image_name;ext4load mmc 0:1 $fdt_addr $fdt_name;setenv bootargs $console root=/dev/mmcblk0p1 rw rootwait; booti $kernel_addr - $fdt_addr'

Now, save your changes.

saveenv

Flashing

1. Write openwrt-18.06.2-mvebu-cortexa53-globalscale-espressobin-squashfs-sdcard.img.gz to a microsd card using the following command:

zcat ~/Downloads/openwrt-18.06.2-mvebu-cortexa53-globalscale-espressobin-squashfs-sdcard.img.gz | sudo dd of=/dev/mmcblk0

2. Run sync before removing the sd card
3. Insert the sd card into the ESPRESSObin and power it on